JL-224B Flat-top Shell Twist Lock light Control Switch

Product introduction
JL-224B rotary lock electronic light control switch series products are applicable to independently control street lighting, garden lighting, passage lighting and doorway lighting according to the natural lighting level of the environment.

This series of products adopts the electronic circuit design with photoelectric transistor sensor and is equipped with surge arresters (MOVs). In particular, JL-224B is equipped with a top sensor for customers to meet the BS5972 standard.

In addition, the preset 5-30 second delay control function can avoid redundant operation caused by spotlight or lightning at night.

This series of products provides latch terminals that meet the requirements of BS5972, and this series also meets CE and RoHS standards.

Product Features
1-BS5972 omnidirectional
2-Time Delay 5-30s
3-Multi-Volts Available
4-Surge Arrester Built-in
5-Phototransistor sensor
6-Use with a BS5972 Twist-lock receptacle

Product Parameter Lists

Installation Instructions
*Disconnect the power supply.
*Connect the socket according to the figure below.
**Push on the ECU and turn it clockwise to lock it in the socket.

Initial Testing
*When the PECU is first installed, it usually takes several seconds to shut down.
*To test “ON” in the daytime, cover the light controller with a black bag or opaque material.
*Do not cover it with your fingers, because the light passing through your fingers may be enough to keep the light controller switch open.
*The light controller test takes about 2 minutes.

JL-224B-12 K IP54
1: B=220-240VAC
C=120-277VAC
2: 12 = MOV 110Joule / 3500Amp
15 = MOV 235Joule / 5000Amp
3: K (optional)=210K socket