JL-428C Swivel Parts Photocell Sensor 120-277VAC

swivel-step-photocell-428C-_01
JL-48C type electronic controller, and by manual directional orient toward sunlight, which can left-right swing horizontal via swivel stem until adjust somewhere point location.
Time delay 5 seconds offers easy-to-test feature while avoiding redundancy operation due to spotlight or lightening during night time.
optional function parameter, such as JL-428CZ include cross-zero technology avoid rush voltage at moment and longer work life. by the way, if you want to choose good lighting solution, then also you considerate not only this light fixture Electrical parameters loading <=1000w, and 1200va ballast @120vac, and you again think which type controller to better suit for our lighting engineer .

Number JL-428C JL-408CZ
Rated Voltage 120-277VAC
Applicable
Voltage Range
105-305VAC
Rated Frequency 50/60Hz
Rated Loading 1000W Tungsten
1200VA Ballast @120VAC 1800VA Ballast @208-277VAC
8A e-Ballast @120VAC 5A e-Ballast @208-277VA
Power Consumption 0.5W Max
Operate Levels 16Lx Turn-On / 24Lx Turn-Of(choose parameter is deponed your choice )
Fail Mode C4:Fail off, C5:Fail On
Surge Protection Opition

swivel-step-photocell-428C-_06

swivel-step-photocell-428C-_02

Disconnect power, remove junction box cover, place the photocontrol in knockout hole and fasten with locknut. Wire according to the diagram in right hand.Do not install the photocontrol with the Photocell facing artificial or reflected light. This will cause the unit to
cycle on and off at night.

 

 

swivel-step-photocell-428C-_05 swivel-step-photocell-428C-_04 swivel-step-photocell-428C-_03

1: Z= Zero cross(option)

2: Lead Rating 16=16 AWG, 105ºC rated 16G=16 AWG 150 ºC rated

3: Lead Length XX, in inches (04 min.)

4: M(option) =UL holographic labe


Post time: Jul-02-2025